Dell EMC PowerProtect DD6400 System Manualità di espansione - Pagina 19
Sfoglia online o scarica il pdf Manualità di espansione per Server Dell EMC PowerProtect DD6400 System. Dell EMC PowerProtect DD6400 System 46.
Topics:
•
Remove filler panels
•
Install an ES40 shelf into the rack
Remove filler panels
The front space of the rack into which you will install the shelf is usually covered by a filler panel. If one or more filler panels
cover the space where you want to install the shelf, use this procedure to remove each panel.
Steps
1. On the filler panel, slide the left and right securing tabs to the open position (towards the center of the panel).
2. Remove the filler panel from the cabinet.
Install an ES40 shelf into the rack
Follow the steps in this section to install the rails, ES40 expansion shelf, and bezel. Follow these steps for each ES40 shelf you
are installing.
There are no specific placement requirements for the ES40 shelves in relation to the DD6400 controller in the rack, as long as
they are close enough to be connected by cables no longer than five meters.
NOTE:
The included cables are one meter. Three and five meter cables are optional lengths.
Installing the rails in the cabinet
About this task
The rails are compatible with racks with square holes, unthreaded round holes, and threaded round holes.
NOTE:
The front edge of each rail is stamped L or R for left or right side with the rail facing the cabinet front.
Install each rail in the cabinet.
Install the Disk Shelves in the Rack
Install the Disk Shelves in the Rack
3
19