Dell EMC PowerProtect DD6400 System Manualità di espansione - Pagina 40
Sfoglia online o scarica il pdf Manualità di espansione per Server Dell EMC PowerProtect DD6400 System. Dell EMC PowerProtect DD6400 System 46.
Stampa la pagina
CLI equivalent
Steps
1. To set up the administrator email, enter:
# config set admin-email [email protected]
The Admin Email is: [email protected]
2. To register the system to the gateway (Secure Remote Support), enter:
# support connectemc device register ipaddr esrs-gateway [host-list] [ha-peer ipaddr]
CAUTION:
When configuring Secure Remove Services delivery on an HA pair:
● The ha-peer parameter is required when configuring Secure Remote Services on HA pairs to register
both nodes.
● The customer must provide Service Link credentials to run the support connectemc device register
command on an HA pair, because attempting to register the HA pair as a user will fail and cause the RSA
key token to become out of synch.
3. To enable the sending of autosupports, enter:
# support notification enable all
Enabled sending autosupport and alerts to EMC.
4. To set the notification method to ConnectEMC, enter:
# support notification method set connectemc
Support notification method set to "connectemc".
5. To show the notification setup, enter:
# support notification show all
Notification
Status
------------
-------
alerts
enabled
autosupport
enabled
------------
-------
6. To show the notification setup, enter:
# support connectemc config show
ConnectEMC configuration:
ESRS gateway IP/hostname:
Registered device IP(s)
7. To test the configuration after enablement, enter:
# support connectemc test
Sending a test event...
40
Configure System for Use
Destination
-----------------------
ftp://111.111.11.111:11
ftp://111.111.11.111:11
-----------------------
esrs-gateway.datadomain.com
10.25.246.70