Dell Force10 MXL Blade Manuale - Pagina 7
Sfoglia online o scarica il pdf Manuale per Server Dell Force10 MXL Blade. Dell Force10 MXL Blade 27. 10/40gbe blade switches
Anche per Dell Force10 MXL Blade: Manuale introduttivo (38 pagine), Nota applicativa (6 pagine), Specifiche tecniche (2 pagine)
Stampa la pagina
Stacking Dell Force10 MXL 10/40G Switches
Another way to completely wipe out all configurations and return to factory defaults is to erase the
meta-data (NVRAM) and delete the startup configuration by following the instructions in Restoring
factory defaults below.
Restoring factory defaults
Usually a standalone MXL can be set to factory defaults simply by deleting the startup configuration
and reloading the switch (Step 2). However, once an MXL has been stacked, additional steps are
required in order to remove the stacking configuration from the NVRAM meta-data. To completely
remove all configurations (including stacking) and return to factory defaults on any stack member:
1. Unplug the stacking cables connecting the switch to the rest of the stack.
2. From the console prompt of the removed switch, type delete startup-configuration and press
enter, then reload the system. If prompted to save the configuration, enter "no".
3. During reboot, press any key at the second prompt to get to the BOOT_USER # menu (the
bootup process allows 5 seconds to press any key to get to this menu).
4. From the BOOT_USER # prompt, type enable admin to get into administrative mode. The
default password is "ncorerulz", which brings up the BOOT_ADMIN # prompt.
5. Type nvram erase <enter>. Then type reload <enter>. When the reload completes, the switch
will be at factory defaults.
Constant stack configuration
A minimum stack configuration is always present on a stack-capable switch. Even if a switch has never
been stacked with other switches, it is still considered a "stack of 1", and therefore will always contain
"stack-unit" lines in the running configuration. Here is an example configuration of a device that is not
stacked.
Note: FTOS starts numbering stack units at zero, so a single stack-unit 0 as shown below is in fact a
stack unit of 1.
FTOS#show running-config
Current Configuration ...
! Version 8.3.16.0E0
! Startup-config last updated at Thu May 3 11:49:39 2012
!
boot system stack-unit 0 primary system: A:
boot system stack-unit 0 secondary system: A:
boot system gateway 172.31.0.1
!
redundancy auto-synchronize full
!
hostname FTOS
!
username root password 7 d7acc8a1dcd4f698 privilege 15
!
stack-unit 0 provision MXL-10/40GbE
!
interface TenGigabitEthernet 0/1
5