Dell Force10 S2410 Manuale di avvio rapido - Pagina 21

Sfoglia online o scarica il pdf Manuale di avvio rapido per Server Dell Force10 S2410. Dell Force10 S2410 31. Installing the s2410 system
Anche per Dell Force10 S2410: Manuale (42 pagine)

Stampa la pagina

After you enable and connect ports in the management VLAN and configure the

management IP address, as described above, you can manage the switch through

a variety of means.

Configuring an Interface with an IP Address

NOTE: You must have the optional SFTOS Layer 3 Package installed to configure

routing commands and to set IP addressing an interface. Use the show version

command to determine what software is installed.

To assign an IP address to an interface, use the following commands:

Step Task

Enables routing for the switch.

Configures an IP address on an

interface. The IP address may be

a secondary IP address.

NOTE: You must configure ip routing at a global level, and 'routing' at an

interface level for you to be able to ping from, and to, the address.

IP configuration takes precedence over VLAN configuration on a port.

Therefore, configuring an IP Address and 'routing' on an interface disables

participation in VLANs on that interface.

Configure a Management Route

On first startup, you have management access only through the console port. If

you want to manage the switch through an IP-based access method (Telnet,

SSH, SNMP, TFTP, etc.), you must configure a management IP interface, using

the following the procedure.

Step Task

Display current management IP

configuration.

Set the IP gateway of the

management interface.

Command Syntax

ip routing

ip address

Command Syntax

show interface

managementethernet

management route default

gateway

Installing the Software

Command Mode

Global Config

Interface Config

Command Mode

User Exec or

Privileged Exec

Global Config