Dell PowerEdge 1300 Manuale di aggiornamento - Pagina 15
Sfoglia online o scarica il pdf Manuale di aggiornamento per Server Dell PowerEdge 1300. Dell PowerEdge 1300 23. Video update
Anche per Dell PowerEdge 1300: Manuale di aggiornamento (24 pagine), Manuale di aggiornamento (2 pagine)
Stampa la pagina
1-12
Dell PowerEdge Systems — Microprocessor Upgrade
2.
Remove the microprocessors.
See "Removing the Microprocessors", found later in this document.
3.
Remove and replace the guide brackets.
See "Removing and Replacing the Guide Brackets", found later in this
document.
4.
Install the upgrade microprocessor.
See "Installing the Upgrade Microprocessor", found later in this document.
5.
Reassemble and check the system.
See "Reassembling and Checking the System", found later in this document.
!" #
To remove the current microprocessors from the system board, perform the follow-
ing steps.
1.
Unscrew and remove the two large thumbscrew retention pins that secure the
microprocessor to the system board.
2.
Press the microprocessor's release latches inward until they snap into position
(see Figure 1-4).
NOTE: Figure 1-4 illustrates the SEC cartridge. The heat sink on the single-edge
connector cartridge 2 (SECC2) package is different.
3.
Grasp the microprocessor assembly firmly and pull it away from the microproces-
sor guide bracket assembly.
You must use up to 15 pounds (lb) of force to disengage the microprocessor
from the connector.