Dell PowerEdge 2410 Manuale - Pagina 5

Sfoglia online o scarica il pdf Manuale per Server Dell PowerEdge 2410. Dell PowerEdge 2410 8. Cabling poweredge t610
Anche per Dell PowerEdge 2410: Manuale (20 pagine), Manuale (20 pagine), Manuale (17 pagine), Manuale (12 pagine), Manuale (10 pagine), Manuale (10 pagine), Manuale (9 pagine), Manuale (9 pagine), Manuale (10 pagine), Manuale (12 pagine), Manuale (11 pagine)

Stampa la pagina

Cable Routing Procedures for Dell™ PowerEdge™ T610 Systems

1.2 Routing the Power Cables Through the Strain Reliefs

After you have installed the tray and cables, route the power cables through the strain reliefs located

on the power supply handles as shown in Figure 2.

Figure 2: Routing Power Cables Through the Strain Reliefs

1.3 Installation of the CMA

The CMA can be installed on either the rear right or rear left side of the rails. Mounting the CMA on the

side that is opposite of the power supplies (right-side mount) is recommended; otherwise, the CMA

must be partially disconnected in order to remove the lower power supply. Refer to Section 3 for

details on power supply replacement.

NOTE: For guidelines on how to route cables within the rack, refer to the Dell

Rack Enclosures

white paper

NOTE: If you are installing fiber-optic cables in the CMA, a cable bend radius of at least 1 inch must be

maintained throughout the length of the cable

on the exterior of the cable bundle to increase the bend radius of the fiber-optic cables through the

CMA. Additionally, a large amount of slack at the entrance and exit of the CMA is recommended.

Install the CMA on either the rear right or rear left side of the rails by attaching both CMA housings

to the attachment brackets on the rails.

2. Route the cables through the CMA while avoiding twisting the cables. Use the hook and loop

straps on the CMA to secure the cables. See Figure 3.

3. If the cable bundle includes a keyboard, video, and mouse (KVM) dongle, place the dongle inside

the CMA basket.

4. Once you have routed all the cables through the CMA, dress the cable slack between the back of

the system and the entrance of the CMA using the tie wraps (shown in yellow in all illustrations)

provided in the CMA kit.

It is recommended that fiber-optic cables be routed

Best Practices Guide for

Page 3