Dell POWEREDGE 4300 Manuale di istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Server Dell POWEREDGE 4300. Dell POWEREDGE 4300 12. System board upgrade
Anche per Dell POWEREDGE 4300: Informazioni sull'installazione (6 pagine), Manuale di installazione (28 pagine), Installazione del rack (37 pagine), Manuale di installazione dell'aggiornamento (14 pagine), Installazione del rack (34 pagine), Manuale di aggiornamento (23 pagine), Manuale di aggiornamento (24 pagine), Manuale di sostituzione (3 pagine), Informazioni sull'installazione (6 pagine), Manuale di installazione (14 pagine)

NOTE: If you purchased your PowerEdge server and PowerEdge Scalable Disk System

100 (SDS 100) storage system at the same time, the SMB connector is preinstalled in

your system and you can skip to the section entitled "Installing the SCSI Cable Strain-

Relief Clip or Bracket."

Before connecting a Dell PowerEdge 6300 or 4300 system to a Dell PowerEdge

SDS 100 storage system, you must install an internal server management bus (SMB)

connector and cable. The cable runs from the system board to the SMB connector on

the back panel to provide a connection point for the external SMB cable from the

SDS 100.

The kit for the internal SMB cable consists of the internal SMB cable and a bracket-

mounted SMB connector for installation on the back panel of the system. Depending

on the SMB installation kit you receive, the SMB connector is mounted on either a

filler bracket for installation in the PCI1 slot or on a bracket that mounts in the general

signal out (GSO) slot.

NOTE: You can use the GSO-mounted SMB connector only if the support panel that

covers the microprocessor compartment inside your system chassis supports installa-

tion of the GSO-mounted SMB connector. You have the proper support panel if your

panel has a cutout that allows the SMB connector to extend through it (see Figure 5).

To install the SMB connector and internal cable, perform the following steps:

Read and follow the precautions in "Safety First—For You and Your Computer" in

Chapter 7 of the Installation and Troubleshooting Guide for your system.

Remove the computer cover and the interior support panel as described in

Chapter 7 of your Installation and Troubleshooting Guide.

SMB Connector and SCSI Cable Strain-Relief Kit Installation Instructions