Dell PowerEdge R420 Manuale - Pagina 8

Sfoglia online o scarica il pdf Manuale per Server Dell PowerEdge R420. Dell PowerEdge R420 11. 2-socket 1u rack server
Anche per Dell PowerEdge R420: Manuale di installazione (8 pagine), Manuale introduttivo (9 pagine), Caratteristiche (2 pagine), Manuale del portafoglio (27 pagine), Manuale tecnico (49 pagine)

Cable Routing Procedures for Dell PowerEdge R320 & R420 Systems

Section 2: Replacing a hot swap power supply on a PowerEdge

R320 or R420 system with a CMA

1. Swing the CMA to its service position as described in the CMA Installation Instructions provided

with the CMA kit.

2. Remove the tray from underneath the CMA as described in the CMA Installation Instructions.

3. Disengage the strain relief and disconnect the power cord from the power supply.

4. Replace the power supply.

5. Plug in the power cord, re-engage the strain relief, replace the CMA support tray, and return the

CMA to the closed (retracted) position.

1. If the innermost power supply must be replaced, then follow the steps described in Section 2.1. If

the outermost power supply must be replaced, follow the steps described below.

2. Swing the CMA to its service position as described in the CMA Installation Instructions provided

with the CMA kit.

3. Remove the tray from underneath the CMA as described in the CMA Installation Instructions.

4. Disengage the strain relief and disconnect the power cord from the power supply.

5. Disconnect both CMA attachment housings from the brackets on the rails as shown in Figure 8.

6. Detach the inner CMA bracket from the rail by pushing on the end of the lock spring and lifting the

bracket up and to the left until it clears the standoffs on the rail.

7. While supporting the CMA with one hand, remove and replace the outer power supply with the

other hand as shown in Figure 9.

8. Reinstall the inner CMA bracket to the rail and reconnect the CMA to the brackets.

9. Plug in the power cord, re-engage the strain relief, replace the CMA support tray, and return the

CMA to the closed (retracted) position.