Dell EqualLogic PS5000 Manutenzione dell'hardware - Pagina 28

Sfoglia online o scarica il pdf Manutenzione dell'hardware per Immagazzinamento Dell EqualLogic PS5000. Dell EqualLogic PS5000 46. Storage arrays
Anche per Dell EqualLogic PS5000: Manuale hardware (50 pagine)

Dell EqualLogic PS5000 Manutenzione dell'hardware
PS5000 Hardware Maintenance
Figure 3-4 shows the recommended network configuration for a dual control
module PS5000 array. This configuration provides the highest network
availability and the maximum network bandwidth.
Figure 3-4: Recommended Dual Control Module Configuration

Removing a Control Module

If a control module fails, you should remove it and replace it with a functioning
control module. You also may need to temporarily remove a control module to
replace a compact flash card.
In a dual control module PS5000 array, you can remove a control module without
shutting down the array, if the remaining control module has at least one
connected and functioning network interface. However, if you remove the active
control module (the LED labeled ACT will be green), there will be a short
interruption as failover to the secondary control module occurs.
Caution: Do not remove a control module from an array while the control
modules are still synchronizing. A message will appear on the console
when synchronization completes. The ACT LED on the secondary
control module will be orange when synchronization completes.
Before removing a control module:
If you have a single control module array, if possible, cleanly shut down the
array before removing the control module to protect against cache data loss.
See Shutting Down and Restarting an Array on page 1-4.
Attach an electrostatic wrist strap, as described in Using an Electrostatic
Wrist Strap on page 1-4.
3–8
Maintaining Control Modules