Dell PowerVault 725N Aggiornamento del firmware - Pagina 4

Sfoglia online o scarica il pdf Aggiornamento del firmware per Immagazzinamento Dell PowerVault 725N. Dell PowerVault 725N 12. Nas systems with software raid
Anche per Dell PowerVault 725N: Manuale di aggiornamento (10 pagine), Aggiornamento delle informazioni (28 pagine)

Stampa la pagina
Dell PowerVault 725N Aggiornamento del firmware
Procedure
To restore your NAS system to the Dell default settings, perform the following steps:
Connect a client system running Windows 2000 to the NAS system.
1
a
b
c
Connect a keyboard, monitor, and mouse to the NAS system.
2
For information about system connectors, see your User's Guide.
Turn on the client system running Windows 2000.
3
Log in to the client system with an account that has administrator privileges.
4
Create a new user with the name pv725 and the password set to password:
5
a
b
c
d
e
f
g
Change the name of the client system running Windows 2000 to pv725rec:
6
a
b
c
d
e
f
1-2
Upgrading Yo ur 39160 SC SI Card Fi r m ware
Shut down the NAS system, and do not turn it back on until instructed.
Turn off the client system, if it is running.
Connect the crossover cable (labeled "Cross Over Ethernet Cable") to the
Ethernet port labeled "LAN 1" on the NAS system and the Ethernet port on the
client system.
From the desktop of your client system, right-click My Computer, and then select
Manage.
On the left side of the Computer Management window, double-click Local Users
and Groups.
Right-click Users and select New User.
In the New User window, type pv725 as the user name.
Type password for the password, and type it again in the Confirm password
field.
Clear the User must change password at next logon check box.
Click Create and then click Close.
From the desktop of your client system, right-click My Computer, and then select
Properties.
In the System Properties window, click Network Identification.
Click Properties.
In the Identification Changes window, type pv725rec for the system name.
Click OK, but do not reboot when prompted.
Click OK to close the Properties window.