•
When configuring network settings for the Default Gateway, you must enter a valid IP address. The library
will not accept a blank value or 0.0.0.0.
•
When drive topology changes are made, the library state may need updating before the partition can be
used. To update the library state, perform one of the following actions:
–
Change the partition state to offline and change the state back to online.
–
Open the library door and close the door 10 seconds later.
–
Remove the drive from the rear of the library and insert the drive one minute later.
–
Reboot the library.
NOTE:
You must use the Web client to manually create partitions. At the initial power-on, partitions can only be created
automatically via the operator panel user interface.
NOTE:
To avoid a possible reduction in performance when using SCSI tape drives, do not install the ML6000-specific
medium changer driver available on http://support.dell.com. You should use the medium changer driver loaded by
default during installation of the operating system.
\____________________
Information in this document is subject to change without notice.
© 2005-2006 Dell Inc. All rights reserved. Printed in the U.S.A.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo, and PowerVault are trademarks of Dell Inc. Other trademarks and trade names
may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any
proprietary interest in trademarks and trade names other than its own.