Dell PowerVault NX400 Impostazione

Sfoglia online o scarica il pdf Impostazione per Immagazzinamento Dell PowerVault NX400. Dell PowerVault NX400 2. Getting started guide
Anche per Dell PowerVault NX400: Manuale di risoluzione dei problemi (17 pagine), Manuale dell'amministratore (50 pagine), Manuale introduttivo (8 pagine)

Stampa la pagina

Setting Up Your Dell PowerVault NAS Solution

Before You Begin

WARNING: Before you set up and operate your Dell PowerVault system, review

the safety instructions that shipped with your system.

Dell Software License Agreement

•

Before using your system, read the Dell Software License Agreement

that came with the system.

•

You must consider any CD, DVD, or diskette set of Dell installed

software as BACKUP copies of the software installed on your system's

hard drive.

•

If you do not accept the terms of the agreement, please call the

customer assistance telephone number. For customers in the United

States, call 800-WWW-DELL (800-999-3355). For customers outside

the United States, visit support.dell.com and select your country or

region from the bottom of the page.

Documentation

For documentation and information updates, see support.dell.com/

manuals.

Cabling the System or Solution Using iSCSI

Dell PowerVault NX400 storage system

Gb1 and Gb2 to Ethernet switch

iDRAC Enterprise port to Ethernet switch for lights-out management (optional)

Verifying Package Contents

Verify that all components listed on your packing slip are available. Save all

documentation and accessories.

Installing the System in a Rack

This system requires a properly grounded electrical outlet, a compatible rack,

and a rack installation kit.

Check for documentation and information updates on support.dell.com/manuals.

Always read the updates ﬁ rst because they often supersede information in other documents.

Locating Your System's Service Tag

•

Your system is identified by a unique Express Service Code and Service Tag

number. The Express Service Code and Service Tag can be found by pulling

out the information tag located at the front of your system.

•

This information is used by Dell to route support calls to the appropriate

personnel.

NOTE:

The illustrations in this document are not intended to represent a speciﬁ c

NAS solution.

Powering-Up and Connecting Your NAS Solution

Power-Up Procedure

You must ﬁ rst turn on the storage arrays and additional expansion enclosure(s), if any. After the storage arrays and enclosure(s) are initialized, turn

on the PowerVault NX400 network-attached storage (NAS) solution.

Connection Procedure

Using a Remote Desktop

If Dynamic Host Conﬁ guration Protocol (DHCP) and Domain Name System (DNS) are implemented on your network, your system automatically

conﬁ gures the network settings. You can launch Remote Desktop from a client and remotely access the NAS system using the default system name.

For example, in the Remote Desktop Connection window, type D<ServiceTag>, where

(letter and number) code, found on a bar-coded label aﬃ xed to your system.

Using Keyboard, Video, and Mouse

Connect a keyboard, monitor, and mouse directly to the NAS system for local administration.

NOTE:

You can also use the optional iDRAC interface for remote administration. For information about initial setup, conﬁ guring iDRAC, and console redirection,

see the Integrated Dell Remote Access Controller 7 User's Guide at supportdell.com/manuals.

Default Password

The default password for the network-attached storage (NAS) system is

Stor@ge!

Default System Name

Your system is configured with a default system name of D<ServiceTag>

where

is a unique five- to seven- digit alphanumeric (letter and

number) code, found on a bar-coded label affixed to your system.

is a unique ﬁ ve- to seven- digit alphanumeric