Dell PowerVault TL4000 Manuale d'uso - Pagina 19

Sfoglia online o scarica il pdf Manuale d'uso per Immagazzinamento Dell PowerVault TL4000. Dell PowerVault TL4000 20. Tape library
Anche per Dell PowerVault TL4000: Note di rilascio (3 pagine), Come iniziare (38 pagine), Faq (26 pagine), Manuale di avvio rapido (7 pagine), Manuale del software (16 pagine), Manuale di configurazione (22 pagine), Informazioni importanti Manuale (10 pagine), Addendum al manuale d'uso (2 pagine), Manuale introduttivo (3 pagine), Istruzioni per l'allegato (17 pagine), Opuscolo (4 pagine)

Stampa la pagina

CAUTION:

Removing components from the upper positions in the

rack cabinet improves rack stability during relocation.

Follow the general guidelines as listed below whenever

you relocate a populated rack cabinet within a room or

building:

v Reduce the weight of the rack cabinet by removing

equipment starting at the top of the rack cabinet. When

possible, restore the rack cabinet to the configuration of

the rack cabinet as you received it. If this configuration

is not known, you must do the following:

– Remove all devices in the 32U position and above.

– Ensure that the heaviest devices are installed in the

bottom of the rack cabinet.

– Ensure that there are no empty U-levels between

devices installed in the rack cabinet below the 32U

level.

v If the rack cabinet you are relocating is part of a suite of

rack cabinets, detach the rack cabinet from the suite.

v Inspect the route that you plan to take to eliminate

potential hazards.

v Verify the route that you choose can hold the weight of

the loaded rack cabinet. Refer to the documentation that

comes with your rack cabinet for the weight of a loaded

rack cabinet.

v Verify that all door openings are at least 762 x 2032 mm

(30 x 80 inches).

v Ensure that all devices, shelves, drawers, doors, and

cables are secure.

v Ensure that the four leveling pads are raised to their

highest position.

v Ensure that there is no stabilizer bracket installed on the

rack cabinet during movement.

v Do not use a ramp inclined at more than ten degrees.

v Once the rack cabinet is in the new location, do the

following:

– Lower the four leveling pads.

– Install stabilizer brackets on the rack cabinet.

– If you remove any of the devices from the rack

cabinet, repopulate the rack cabinet from the lowest

position to the highest position.

v If a long distance relocation is required, restore the rack

cabinet to the configuration of the rack cabinet as you

received it. Pack the rack cabinet in the original

packaging material, or equivalent. Also lower the

leveling pads to raise the casters off of the pallet and

bolt the rack cabinet to the pallet.

Safety and Environmental Notices

xvii