3 Day Blinds Faux Wood 1 Come iniziare - Pagina 3

Sfoglia online o scarica il pdf Come iniziare per Tende per finestre 3 Day Blinds Faux Wood 1. 3 Day Blinds Faux Wood 1 6.

Stampa la pagina

OUTSIDE MOUNT

TO INSTALL THE END MOUNTING BRACKETS:

• Unwrap the cellophane from around the blind stack.

Caution: DO NOT cut the cellophane as the cords or ladders

supporting the blind may be inadvertently cut.

• Lower the blind to its full length. (See "Blind Operation")

| 1" Faux Wood Blinds

• Hold the blind up to the

desired mounting position.

• Once the blind is level,

mark the wall at the lower

corners of each end of the

headrail using a pencil

• Draw the blind completely

up and set it aside.

• Using a flathead

screwdriver, open the

latches of the end

brackets.

• Facing the window,

position the end bracket

marked "LH" above the

top left corner of the

window,

" TO THE LEFT

of the pencil marks.

• Using a pencil, mark the

wall through the holes

in the back of the end

bracket. For maximum

stability, the pencil

marks should be made

diagonally.

• Using a drill with a

" drill

bit or an awl, make a small

pilot hole at each pencil

mark.

• Mount the bracket

using two of the screws

provided.

• Repeat this procedure

for the right end bracket,

making sure the end

bracket marked "RH" is

positioned above the

top right corner of the

window,

" TO THE

RIGHT of the pencil marks.

TO INSTALL CENTER SUPPORT BRACKET(S):

Proceed to "Blind Installation".

• If your hardware packet

includes one center

support bracket, position

it as close to the center

of the mounting surface

as possible, making

sure it will not interfere

with any moving parts.

If more than one center

support bracket has been

provided, position them

equidistant from the end

brackets and each other,

again avoiding all moving

parts.

• Make sure all center

support brackets are

positioned at the same

height and are level with

the end brackets.

• Using a pencil, mark the

mounting surface through

the holes in the back

of the center support

bracket. For maximum

stability, the pencil marks

should be made in the top

two holes of the center

support bracket.

• Using a drill with a 1/16"

drill bit or an awl, make

a small pilot hole at each

pencil mark.

• Mount the bracket

using two of the screws

provided.

• Repeat this procedure

for any remaining center

support bracket(s).