Dell Force10 S4810P Manuale di avvio rapido - Pagina 17

Sfoglia online o scarica il pdf Manuale di avvio rapido per Interruttore Dell Force10 S4810P. Dell Force10 S4810P 27. Quick start guide

Installing the Software

The FTOS prompt changes to indicate the CLI mode. You must move linearly

through the command modes, with the exception of the end command which

takes you directly to EXEC Privilege mode; the exit command moves you up

one command mode level.

NOTE: Before starting this procedure, be sure you have a terminal emulation

program already installed on your PC.

The RS-232 console port is labeled on the S4810 chassis. It is in the upper right-

hand side, as you face the I/O side of the chassis.

RJ-45

Console Port

Step

Task

Install an RJ-45 copper cable into the console port. Use a rollover cable to

connect the S4810 console port to a terminal server.

Connect the other end of the cable to the DTE terminal server.

Default terminal settings on the console port are set as follows:

9600 baud rate

No parity

8 data bits

1 stop bit

No flow control

Installing the Software