Dell Networking N30 Series Manuale di installazione - Pagina 40

Sfoglia online o scarica il pdf Manuale di installazione per Interruttore Dell Networking N30 Series. Dell Networking N30 Series 49.

Starting and Configuring the N30xx System

This section explains how to start and configure the N30xx system.

Topics:

•

•

Connecting N30xx Switch to Power Source

•

Booting the N30xx Switch

•

Initial Configuration

Connecting an N30xx Switch to a Terminal

After completing all external connections, connect a terminal to a switch to configure the switch.

NOTE:

Read the Release Notes for this product before proceeding. Dell Networking recommends obtaining the most recent

version of the user documentation from the Dell Support website at http://www.dell.com/support.

To monitor and configure the switch using the serial console, use the console port on the I/O-side of the switch. Connect it to a VT100

terminal or to a computer running VT100 terminal emulation software. Implement the console port as a data terminal equipment (DTE)

connector.

The following equipment is required to use the console port:

•

VT100-compatible terminal or a computer with a serial port running VT100 terminal emulation software, such as Microsoft

HyperTerminal.

•

A serial cable (provided) with an RJ-45 connector for the console port and DB-9 connector for the terminal.

To connect a terminal to the switch console port,

Connect the DB-9 connector on the serial cable to the terminal or computer running VT100 terminal emulation software.

Configure the terminal emulation software as follows:

Select the appropriate serial port (for example, COM 1) to connect to the console.

b Set the data rate to 9600 baud.

Set the data format to 8 data bits, 1 stop bit, and no parity.

d Set the flow control to none.

Set the terminal emulation mode to VT100.

Select Terminal keys for Function, Arrow, and Ctrl keys. Make sure that the setting is for Terminal keys (not Microsoft

Windows keys).

Connect the RJ-45 connector on the cable directly to the switch console port. The Dell Networking console port is on the right side

of the I/O-side and is labeled with a |O|O| symbol.

NOTE:

Serial console access to the stack manager is available from any serial port using the local CLI. Only one serial

console session at a time is supported.

Starting and Configuring the N30xx System