Dell PowerConnect 5500 Series Manuale di configurazione rapida - Pagina 7

Sfoglia online o scarica il pdf Manuale di configurazione rapida per Interruttore Dell PowerConnect 5500 Series. Dell PowerConnect 5500 Series 17. Networking mobility starter kit

Stampa la pagina

Dell Networking Mobility Starter Kit – Quick Setup Guide

3. The Setup Wizard is run automatically .The Setup Wizard displays the following information:

Welcome to Dell Easy Setup Wizard

The Setup Wizard guides you through the initial switch configuration

and gets you up and running easily and quickly. You can skip the

Setup Wizard and enter CLI mode to manually configure the switch.

The system will prompt you with a default answer; by pressing Enter,

you accept the default value.

You must respond to the next question to run the Setup Wizard within

60 seconds, otherwise the system will continue with normal operation

using the default system configuration.

Would you like to enter the Setup Wizard (you must answer this

question within 60 seconds)? (Y/N)

4. Enter [Y] to run the wizard.

After entering [Y] the wizard provides interactive guidance through the initial switch

configuration. The following information is displayed:

You can exit the Setup Wizard at any time by entering [ctrl+Z].

The system is not set up for SNMP management by default.

If you enter [N] or if you do not respond within 60 seconds, the Setup Wizard automatically

exits and the CLI console prompt is displayed.

To manage the switch using SNMP (optional, required for OMNM) you can:

•

Setup the initial SNMP version 2 account now.

•

Return later and setup the SNMP version account.

For more information on setting up an SNMP version 2 account, see the Dell PowerConnect 5500

Series User Guide and Getting Started Guide at support.dell.com/manuals.

Would you like to set up the SNMP management interface now? [Y/N]

NOTE: If you are not setting up OMNM at this time and cannot obtain the SNMP information

in steps 6 and 7, enter [N] to skip to step 8. It is recommended to setup SNMP within this Setup

Wizard if you intend on using OMNM.

5. Enter [N] to skip to Step 8 or enter [Y] to continue the Setup Wizard. If you enter [Y] the

following information is displayed:

To set up the SNMP management account you must specify the management

system IP address and the "community string" or password that the

particular management system uses to access the switch. The wizard

automatically assigns the highest access level [Privilege Level 15] to

this account.

You can use Dell Network Manager or other management interfaces to

change this setting later and to add additional management system

later. For more information on adding management systems, see the user

documentation.