Dell PowerConnect 8164F Manuale di configurazione - Pagina 12
Sfoglia online o scarica il pdf Manuale di configurazione per Interruttore Dell PowerConnect 8164F. Dell PowerConnect 8164F 17. Powerconnect 8100 series high-performance 10/40 gbe enterprise switches
Anche per Dell PowerConnect 8164F: Specifiche tecniche (3 pagine)
Stampa la pagina
3
Configure Data Center Bridging (DCB) (Optional)
DCB is enabled by default. This section shows the steps required to configure DCB.
Note: You must complete the Dell recommended switch configuration steps in Sections 2.1 to 2.12
before configuring the switch for DCB mode.
3.1
Enable DCB
If DCB was previously disabled, it must be manually re-enabled.
console#configure
console(config)#dcb enable
3.2
Create VLAN
console#configure
console(conf)# vlan vlan-id
Note: You must supply a VLAN id. The valid range is 2-4093.
console(conf)#exit
3.3
Configure class of service, dot1p mapping, and traffic class
console(config)#iscsi cos enable
console(config)#iscsi cos vpt 4
console(config)#classofservice dot1p-mapping 4 4
console(config)#classofservice traffic-class-group 4 1
3.4
Configure Priority flow control on switch ports and port channel
console(config)#interface range tengigabitethernet all
console(config-if)#datacenter-bridging
console(config-if-dcb)#priority-flow-control mode on
console(config-if-dcb)#priority-flow-control priority 4 no-drop
console(config-if-dcb)#exit
console(config-if)#switchport mode trunk
12
SCG1001
Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide