AVX AVX-SAT4 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti AVX AVX-SAT4. AVX AVX-SAT4 6. 70v / 100v / 8 ohm outdoor landscape speakers

Stampa la pagina

Speaker Connections

Ensuring correct polarity ('+' to'+' & '-' to '-') is essential to the performance of any loudspeaker within an

audio system.

Performing the

i l e

b a

i l i

. y t

Warning! Leave the amplifier unpowered and disconnected from the speaker line until all other connections

have been made.

Warning! The silicone-filled weatherized wire

nuts included with this kit are designed to be

used for direct burial installations. An

equivalent connector must be used for any

wiring in the system that could be exposed to

water or weather.

Damage to loudspeakers or connected

equipment due to inadequate or improper

installation will not be covered under warranty.

1. Install the loudspeaker mount to the

loudspeaker.

2. Route the loudspeaker cable into the

loudspeaker mount. Take care not to

damage the wire insulation.

3. Strip the outer jacket of the cable to separate it from the insulated wires inside by at least 2 inches. If a

location has a wire loop instead of an end, cut the wire to make a splice point.

4. Strip the insulation on each conductor back approximately ½ inch.

5. Twist the wire/s from the run together with the loudspeaker wire in a clockwise direction; all – ( negative)

wires together and all + (positive) wires together.

6. Insert each set of wires into a (waterproof) wire nut and twist the nut clockwise until it is firmly seated. Make

sure the wire nut completely covers the bare copper. A small amount of silicone may press out of the wire

nut as the wires are inserted; this is normal and should be left on the wire for the most reliable connection.

7. Close or secure the connections and the loudspeaker mount per the mount instructions or local building

codes.

8. Set the transformer switch to the correct tap setting per the Transformer Tap Settings section before

connecting an amplifier to the system. (70v, 100v or 8 ohms)

Transformer Tap Settings

SAT loudspeakers have an adjustable tap setting switch located

under the removable rear cover. To adjust the setting, use a flat or #2

Phillips screwdriver to rotate the tap setting dial on the rear of the

speaker to the desired mark. When the adjustments are complete and

fully tested, install the rear cover of the speaker and hand tighten it

until secure.

SAT speakers used in 70/100 volt systems can be set to different

wattages for more or less volume at one particular speaker. This

makes it much easier to adjust a system for even listening volume.

Warning! The SAT loudspeaker tap must be set accordingly for the

type of amplifier in use (8Ω or 70/100volt). Setting the transformer

incorrectly for the amplifier used will cause damage to speakers and

/ or amplifier and is not covered under warranty.

l o

o l

i w

g n

e t

s p

l l i

n e

u s

e r

o c

r r

c e

c t

n o

e n

i t c

n o

f s

r o

p o

i t

e p

f r

r o

70V/100V

40W RMS

80Watts MAX

AVX-SAT4

and

n a

e c