Dell PowerSwitch E3200-ON Series Manuale di installazione - Pagina 8

Sfoglia online o scarica il pdf Manuale di installazione per Interruttore Dell PowerSwitch E3200-ON Series. Dell PowerSwitch E3200-ON Series 10.

MPS-1S wall mount

Use the four wall-mount brackets to attach an external power supply (EPS) to the wall.

NOTE:

Do not wall mount the EPS with the front panel/PSU facing up or down.

You need a drill and a pencil to complete this procedure. This procedure applies to one EPS.

1. Remove the wall-mount brackets, wall anchors, and screws from the shipping bag.

This procedure uses four wall mount anchors, four M5 screws (length 16 mm), and eight M4 screws (length 6.8 mm).

2. Screw two brackets to the left side of the EPS using the M4 screws (length 6.8 mm) for each bracket, as shown.

Torque the screws to 10 in-lbs.

3. Repeat to attach two brackets to the right side of the EPS, as shown.

4. Hold the EPS or wall-mount template to the wall and mark the screw-hole locations on the wall with the pencil.

Wall mount locations for MPS-1S are approximately 8.37 in x 6.76 in (212.60 mm x 171.85 mm) (L x W).

N-Series EPS installation