Entec EW-4200D Manuale di istruzioni per l'uso - Pagina 19

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Generatore portatile Entec EW-4200D. Entec EW-4200D 19. Marine diesel generators

Stampa la pagina

Theory of Operation

EW-4200D

Injection Pump and Injector. The injection pump is like a

miniature piston and cylinder with a special valve. When the

miniture piston is pulled down, fuel is drawn into the cylinder.

When the piston is pushed up, the fuel is forced through a

special check valve and into the high pressure pipe (11/11)

leading to the injector. The pipe is full of fuel, so whatever

quantity is forced into the pipe at the injection pump end, must

come out at the injector end and into the injector. The injector is

a special combination check valve and atomizer that will open

when the pressure in the pipe reaches 2,900 psi. The injector has

a tip with tiny holes that causes the fuel to be sprayed as a fine

mist, or atomized. At the top of the compression stroke the fuel

is sprayed into the very hot compressed air and ignites.

Ignition Temperature. To reach ignition temperatures during

the compression stroke, the piston must travel at a fast enough

speed to prevent the loss of heat. A weak battery, or dirty cable

terminals, etc. will not turn the engine fast enough to prevent the

heat loss.

The same is true for hand cranking speed. A timid hand cranker

will never start the engine by hand.

Fuel Efficiency. The injection pump is controlled by the engine

governor (7/12 & 13) and throttle control (5/1 –13) system that

tells the injection pump how much fuel should be delivered to

the injector. This quantity is established every single time the

engine reaches the end of the compression stroke. You can think

of the fuel flow as a series of fuel "slugs," happening at a rate of

1,800 times per minute for our 60 cycle generator. The injection

pump always delivers just the right quantity fuel that the gover-

nor demands, to produce the horsepower needed, to make the

exact amount of electrical power the vessel needs at any given

point in time.

If the generator load was 30 amps, then calculate 0.4 gallon per

hour fuel consumption, divided by 60 minutes per hour, and

divide that by 1,800 injection pulses per minute, and you can get

an idea of how small each "slug" of fuel is.

For Example: 231 cubic inches of fuel in a gallon, multiplied by

0.4, divided by 60, then divided by 1800, equals 0.00086 cubic

inches of fuel per "slug".

231

0.4

1800

0.00086

If the load was 10 amps, the "slug" would be approximately 1/3

of 0.00086 cubic inches, or 0.00029 cubic inches.

Entec West, Inc.

16710 SW 72nd • Portland, Oregon 97224 • (503) 624-7118