Dell S6000-ON Manuale di installazione - Pagina 26

Sfoglia online o scarica il pdf Manuale di installazione per Interruttore Dell S6000-ON. Dell S6000-ON 41. Open networking
Anche per Dell S6000-ON: Manuale introduttivo (26 pagine), Manuale di risoluzione dei problemi (29 pagine)

Stampa la pagina

Figure 13. PSU installation

1—PSU

2—Slot

When you install the PSU correctly, it snaps into place and is flushed with the back of the switch.

Plug in the appropriate AC three prong cord from the switch PSU to the external power source.

Repeat steps 1 through 4 if you have a second power supply using the second PSU slot on the S6000-ON system.

NOTE:

The S6000-ON powers up when the cables are connected between the power supply and the power source.

AC power supply replacement

CAUTION:

Disconnect the power cord before removing the power supplies. Also, disconnect all power cords before servicing.

NOTE:

The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may damage the PSU or the S6000–

ON chassis.

NOTE:

If a PSU fails, you must replace the entire unit. There are no field serviceable components in the PSU. To request a

hardware replacement, see

NOTE:

If you use a single PSU, install a blank plate in the other PSU slot. Dell EMC recommends using power supply 2 (PSU2) as

the blank plate slot.

Disconnect the power cable from the PSU.

Use the grab handle to slide the PSU out of the power supply bay.

Use the grab handle on the replacement PSU to slide it into the power supply bay.

Attach the power cord to the replacement PSU.

NOTE:

The system powers up when the cables are connected between the power supply and the power source.

Power supplies

Technical

Support.