Dell X1000 Series Manuale introduttivo - Pagina 10

Sfoglia online o scarica il pdf Manuale introduttivo per Interruttore Dell X1000 Series. Dell X1000 Series 43.

2 Connect the switch to a PC using Ethernet, and set a static IP address

of 192.168.2.x (where x is between 2 and 254) and subnet mask of

255.255.255.0 on the PC. Note that the switch acts as a DHCP client

and can receive its IP address from a DHCP server. If using DHCP for IP

assignment, look up the assigned IP address and use it for the next step.

3 Connect to the switch using the default switch IP address 192.168.2.1 in

your web browser. The login username is admin with password admin.

4 After logging into the switch using the previous step, a getting started wizard

is available to guide the user through the initial switch configuration.

Applied changes are automatically saved to the startup configuration.

CLI Access

To access the switch using the Command Line Interface (CLI), it must be in

Managed Mode. The Command Line Interface can only be reached by using

telnet or a console connection. See the user guide for limited CLI options.

NOTE:

The default switch setting is Unmanaged Mode. To set the switch to

Managed Mode, press the Mode button for at least seven seconds.

Connecting the Switch to a Terminal Server/PC

NOTE:

The console port enables connecting to a terminal or desktop system

running terminal emulation software for monitoring or debugging the device

using the micro-USB port. (You can find the USB drivers at dell.com/support.)

To use the console port, the following is required (e.g., PuTTY, TeraTerm, etc.)

•

VT100 compatible terminal or a desktop or portable system with a USB

port and running VT100 terminal emulation software.

To connect a terminal to the device console port, verify that the terminal

emulation software is set as follows:

1 Set the data rate to 9600 baud, data format to 8 data bits, 1 stop bit and

no parity.

2 Set flow control to none.

3 Select VT100 for Emulation mode.

Getting Started Guide