EarthPulse Command V.5 Manuale di avvio rapido - Pagina 5

Sfoglia online o scarica il pdf Manuale di avvio rapido per Prodotti per la cura della persona EarthPulse Command V.5. EarthPulse Command V.5 7.

C) Testing Magnetic Output:

1) With blue-diode blinking; Lay the fatter rounded side of the ring

across the center of the solid electromagnet core (as shown in photo

below);

2) Raise ring 1/4-1/2 inch (1-2 cm) above core to feel pulsing signal;

3) Move to 3/4 inch or 2-3 cm above core and it is very weak if not

relatively unnoticeable;

4) Use UP/DOWN arrow keys in active mode while holding ring at

1/4 inch (1MM) position to feel amplitude change.

under feather pillow in Alert-Mode (maximum pulse rate). If this com-

pletely safe level of heat makes you uneasy, operate at lower ampli-

tude when magnet is trapped in bedding.

While it may feel hot to touch on the palm side of hand, it should feel

a bit more than warm to the back of hand. At boot amplitude (70%) it

will be slightly more powerful than our last version (v.4.7) with little to

no heat depending upon type of cushions and ambient temperature.

Testing magnet output