EarthQuake PH10000W/D1 Manuale d'uso - Pagina 9
Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore EarthQuake PH10000W/D1. EarthQuake PH10000W/D1 10. Powerhouse series amplifiers
Anche per EarthQuake PH10000W/D1: Opuscolo (8 pagine), Manuale d'uso (11 pagine), Manuale d'uso (10 pagine)
Stampa la pagina
PH10000W/ 1
D
High Level
RCA, Low
RCA, Low
speaker input
Level input
Level out
This switch will reverse the phase of PH10000's
output with respect to its input. Although the position
that yields the most upper bass is technically correct,
you may choose the position that better suits your
needs.
FUSE RATING SHOULD BE
NO LESS THAN 120 AMPERES
PER AMPLIFIER
DO NOT SOLDER THE TIP OF THE POWER
CABLE (+&-). IT REDUCES THE CONTACT
SURFACE BETWEEN THE CABLE AND THE
INSIDE
OF
THE
TERMINAL.
WHEN
TIGHTENING THE SCREW, A RAW CABLE (NO
SOLDER) EXPANDS INSIDE THE TERMINAL
CREATING LARGER CONTACT SURFACE;
THUS ELIMINATING HOT JUNCTIONS.
Speaker output
16
Specifications Are Subject To Change Without Notice
The low-pass filter,
This switch will line
blocks unwanted high
match the voltage of your
frequencies to allow
head unit, which will
cleaner low-frequencies.
deliver high sound quality
and performance.
Peaks or dips occur at about 40Hz —
around the frequency of a low bass
guitar
note.
Use
this
to correct that peak or dip.
The gain knob is not a volume control.
It is designed to match the input level
of the amp to the output level of the
source unit. Over driving -clipping- the
input stage of the amp will cause
damage to the amplifier (Please refer
to table for settings).
GND
BAT
REM
To battery (+)
To car chassis / ground
To remote turn on / trigger
"RCA level" audio signal needed to clip the input stage (bass boost at minimum)
control
"RCA level" audio signal needed to clip the input stage (bass boost at maximum)
"SPEAKER level" audio signal needed to clip the input stage (bass boost at minimum)
"SPEAKER level" audio signal needed to clip the input stage (bass boost at maximum)
17
www.earthquakesound.com