EarthQuake 9800BCE Manuale dell'operatore - Pagina 13
Sfoglia online o scarica il pdf Manuale dell'operatore per Attrezzature per prato e giardino EarthQuake 9800BCE. EarthQuake 9800BCE 20. Two-man earth auger powerhead
Anche per EarthQuake 9800BCE: Manuale dell'operatore (19 pagine)
Stampa la paginaTROUBLESHOOTING GUIDE
While normal care and routine maintenance will extend the life
of your auger powerhead, prolonged or constant use may even-
tually require that service be performed to allow it to continue
operating properly. The troubleshooting guide below lists the
most common problems, causes and remedies.
PROBLEM
Engine will not start
Engine runs rough, floods during
operation
Engine is hard to start
Engine misses or lacks power
Auger turns at idle
Auger turns, but has no power
Auger cuts slowly
Engine runs, then quits
NOTE: Please see the engine manual for any engine issues.
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
POSSIBLE CAUSE
1. Power switch off
2. Spark plug wire disconnected
3. Fuel valve closed
1. Dirty air cleaner
2. Carburetor out of adjustment
3. Fuel valve closed
1. Stale fuel
2. Spark plug wire loose
3. Dirty carburetor
1. Clogged fuel tank
2. Clogged air cleaner
3. Improper carburetor adjustment
4. Spark plug dirty, improper gap, or wrong
type
1. Idle speed too high
2. Broken clutch spring
1. Carburetor out of adjustment
2. Broken transmission
3. Worn clutch shoes
4. Worn engine lower seal
1. Damaged point
2. Worn out blade
1. Screen in carburetor plugged
2. Fuel valve closed
Two-Man Earth Auger Powerhead 9800 Series
CAUTION
PRACTICE SAFETY AT ALL TIMES. ENGINE MUST BE
TURNED OFF AND ALLOWED TO COOL, AND SPARK
PLUG WIRE MUST BE DISCONNEC TED BEFORE
ATTEMPTING ANY MAINTENANCE OR REPAIR.
REMEDY/ACTION
1. Flip switch to ON position
2. Connect spark plug wire to spark plug
3. Open fuel valve
1. Clean or replace air cleaner
2. Take to authorized Briggs & Stratton/Honda
service center
3. Open fuel valve
1. Drain old fuel and replace with fresh. Use gas stabi-
lizer at end of season
2. Make sure spark wire is securely attached to spark
plug
3. Clean carburetor, use gas stabilizer, new gas can
1. Remove and clean
2. Clean or replace
3. Take to authorized Briggs & Stratton/Honda service
center
4. Replace spark plug and adjust gap
1. Adjust idle speed lower
2. Replace both springs
1. Take to authorized Briggs & Stratton/Honda service
center
2. Replace transmission
3. Replace clutch
4. Take to authorized Briggs & Stratton / Honda ser-
vice center
1. Replace fishtail point
2. Replace blade
1. Clean screen, use gas stabilizer, clean gas can
2. Open fuel valve
Operator's Manual
13