EarthWay 2100P Estate Manuale di montaggio e istruzioni per l'uso
Sfoglia online o scarica il pdf Manuale di montaggio e istruzioni per l'uso per Spreader EarthWay 2100P Estate. EarthWay 2100P Estate 8. Broadcast spreader
Anche per EarthWay 2100P Estate: Manuale di montaggio e istruzioni per l'uso (6 pagine)
Stampa la pagina
2100P E
statE
B
roadcast
ASSEMBLY and OPERATING INSTRUCTIONS
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671,
HELPFUL HINTS:
; If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The
impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller
plate after each use. Fertilizer stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds
will change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your
spreader thoroughly after each use. Coat all metal surfaces (inside & outside of chassis tubes) with light oil or silicon spray
to help prevent corrosion. Wash between the shut off plate and bottom of the hopper. Do not use powdered materials.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
Lower
Axle
Housing Clip
Bushing
Bearing
¼-20
Lock Nut
#12 x 1¼"
Flat Head Screw
Axle
Washer
Agitator
¼-20
#10 x ⅝"
Hex Nut
Screw
1. Remove and identify all loose parts from carton
(Qty 4) #31105
#12 X 1¼"
Flat Head Screw
s
PrEadEr
READ THE DIRECTIONS BEFORE ASSEMBLY
⅛ x ¾"
⅛ x 1¼"
Cotter Pin
Cotter Pin
Axle
¼-20 x
¼-20 x 1¾"
1½" Bolt
Carriage Bolt
¼-20 x
1¼" Bolt
¼-20 x
2" Bolt
.
2. Position the Hopper on its top as shown
to the left. Install frame using (4) #12 x
1¼" Flat Head Phillips screws. TIGHTEN
THESE NOW - use care to not over tighten
:
@
Email
tEchsuPPort
Earthway
⅛ x 1¾"
Cotter Pin
FRAME
IMPELLER
Warning
Remove agitator when
using Rock Salt to prevent
gearbox damage
.
com
UPPER HANDLE
ASSEMBLY
CONTROL
ASSEMBLY
DRAW BAR
&
BRACE ASSEMBLY
GEARBOX
AXLE
9-2014 Pt.# 52159
MADE IN THE USA
PAGE 1