EarthWay EV-N-SPRED C22HD Manuale di montaggio e istruzioni per l'uso
Sfoglia online o scarica il pdf Manuale di montaggio e istruzioni per l'uso per Spreader EarthWay EV-N-SPRED C22HD. EarthWay EV-N-SPRED C22HD 6. Broadcast spreader
Anche per EarthWay EV-N-SPRED C22HD: Manuale di montaggio e istruzioni per l'uso (6 pagine), Manuale di montaggio e istruzioni per l'uso (8 pagine)
Stampa la pagina
C22HD & C22HDS B
ASSEMBLY and OPERATING INSTRUCTIONS
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, email: [email protected], or SKYPE: EARTHWAY.TECH
HELPFUL HINTS:
; If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must
turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller after each use as some
fertilizer may become stuck on the impeller blades and will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader thoroughly after each
use. Wash between the shut off plate and bottom of the hopper.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
; If you must use Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily. Rock Salt
will reconstitute back into a solid block over night with humidity and will damage your spreader. Do not use any powdered materials.
If you have any trouble assembling this spreader, we have Assembly Videos for each
s
of this manual available online at www.earthway.com/product/professional-spreaders/video
tep
s
1
tep
33117
36305
Qty 1
Qty 2
36200
Qty 8
31104
Qty 4
Gauge Overlay is snapped over the
metal gauge. Replace the stop bolt
assembly to secure overlay on the
gauge.
(Qty 4) #31104
#14 X 1-1/2"
Flat Head Screw
roadcast
36404
36300
Qty 18
Qty 11
36105
Qty 1
36104
Qty 1
36205
36103
Qty 3
Qty 1
36207
Qty 2
2. Position hopper on top as shown. Install
frame using (4) #14 x 1-1/2" Flat Head
Phillips screws. TIGHTEN THESE NOW.
s
preader
Upper Handle
Handle
Shaft
Frame
Impeller
Frame
1. Remove and identify all of the loose parts from carton.
ROCK SALT and POWDERED MATERIALS
should not be used in this spreader as it will
damage gearbox and can void warranty.
Use only granular materials.
EarthWay
EarthWay
EV-N-SPRED
EV-N-SPRED
Rev 1.10
Cross
Brace
Gauge & Lever
Lower
Brace
Handles
Pivot
Gearbox
Pt# 52153
®
®
GT
GT
Control
Rod
Pivot
Rod
PAGE 1