EarthWay EV-N-Spred C22HDS Manuale di montaggio e istruzioni per l'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale di montaggio e istruzioni per l'uso per Spreader EarthWay EV-N-Spred C22HDS. EarthWay EV-N-Spred C22HDS 8. Broadcast spreader
Anche per EarthWay EV-N-Spred C22HDS: Manuale di montaggio e istruzioni per l'uso (6 pagine), Manuale di montaggio e istruzioni per l'uso (6 pagine)

1" Cotter Pin

7. NOTE: BEFORE INSTALLING THE GAUGE & LEVER ASSEMBLY AND UPPER HANDLE TO

THE HANDLE SHAFT, SELECT THE BEST POSITION FOR THE OPERATOR'S COMFORT. You

can select lower or upper positions for best fit to the operator's height. Insert 2¾" bolt through the Gauge,

then upper handle and finally through handle shaft. See example to the right.

8. Insert pivot rod into shut off plate as shown above. [TIP: Insert rod end from the top, then push down &

turn to lock in place.]

9. Insert other end of pivot rod into pivot and bracket assembly as shown. [TIP: Insert rod end from the side

that has the angle attached to the bracket, then turn to lock in place as shown at the right and above. The

correct positioning of the Pivot Bracket has the Angle and Attaching Arm facing away from the gearbox.]

2" Cotter Pin

2 Position Handle

Insert Pivot Rod

into Shut-Off

and rotate to secure

DO NOT TIGHTEN LOCKNUT YET.

6. Install drive wheel to axle using pin hole nearest to lower

handles as shown. Insert 2" cotter pin through wheel and

through axle. Bend with pliers to prevent pin from falling

out.

Install coast wheel to axle, and then using outside pin

hole on the axle (as shown on the left), insert 1" cotter pin

through axle [NOTE: not thru the wheel]. Bend with pliers

to prevent pin from falling out.

TURN SPREADER UPRIGHT ON TO WHEELS

If you have any questions

please call 1-574-848-7491

Lower Position

Upper Position

¼-20

Lock Nut

and

(Cupped Washer

for C22HD)

Angle

Attaching

Arm

¼-20 x 2¾"

Hex Head Bolt

¼-20 x 2¼"

Hex Head Bolt

and (Cupped Washer

for C22HD)

PAGE 3