Miele PWM 507 DP Hygiene/Special Piano di installazione - Pagina 11
Sfoglia online o scarica il pdf Piano di installazione per Lavatrice Miele PWM 507 DP Hygiene/Special. Miele PWM 507 DP Hygiene/Special 12.
Stampa la pagina
PWM 507
Connecting the drain hose to a laundry trough or wash tub drain
outlet
The drain hose with the non-return valve fitted can be connected
securely to a suitable wash tub drain outlet.
If required, the hose can be extended to a length of up to 5 m. The
necessary parts can be ordered from Miele (depending on country).
For a delivery head of more than 1 m (up to a max. of 1.6 m) a
replacement drain pump will need to be fitted. Please contact Miele for
advice.
Waste water discharge from commercial clothes washing machines
may require pre-treatment as determined by the utility operator.
Equipotential bonding
If necessary, equipotential bonding with good galvanic contact must
be guaranteed in compliance with all applicable local and national
installation specifications.
Connection material for equipotential bonding must be provided on
site or using a kit available from Miele.
Peak load/energy management
The appliance can be connected to a peak-load or energy
management system using an optional kit.
When the peak load function is activated, the heating is switched off.
A message appears in the display to inform you of this.
Liquid dispensing connection
External liquid dispenser pumps with a "container empty" indicator can
be used to dispense liquid detergents.
The dispenser pumps can only be programmed with MDU.
It is particularly important to observe the manufacturer's instructions
when using a combination of detergents, additives and special-
purpose products.
Payment system
This washing machine can be fitted with a single-machine payment
system as an optional accessory using an optional kit (XCI box).
The programming required for connecting a payment system can be
carried out during the initial commissioning process. After initial
commissioning, changes can only be made by your Miele dealer or by
Miele Professional Service.
11 284 900/00
Interface
The appliance can be fitted with an XKM 3200 WL PLT
communication module. This module can be used as a Wi-Fi or LAN
interface.
The LAN interface provided via the module complies with
AS/NZS 60950. The LAN connection uses an RJ45 connector in
accordance with EIA/TIA 568-B.
Installation
The machine must be installed on a perfectly smooth, level and firm
surface which is able to withstand the quoted loads.
The floor load created by the machine is concentrated and transferred
to the installation footprint via the machine feet.
The machine should be levelled in both directions with the aid of the
adjustable feet.
Plinth installation
The washing machine can be installed on a machine plinth (open or
box plinth, available as an optional Miele accessory) or on a concrete
platform to be provided on site.
The quality of the concrete and its strength must be assessed
according to the machine load. Ensure that any raised concrete plinth
is adequately bonded to the floor below.
If the washing machine is installed on a concrete or masonry plinth, it
must be secured using the anchors supplied with the machine.
Otherwise, there is the danger of the washing machine falling off the
plinth during spinning.
The anchors provided can be used to bolt the machine to the floor by
both front feet. The fixing material provided is intended to be used for
bolting the machine to a concrete floor.
Washer-dryer stack
This washing machine can be installed with a Miele tumble dryer on
top of it. A stacking kit (optional accessory) is required for this.
The stacking kit must be installed by Miele Professional Service or an
authorised Miele service technician.
en-AU, NZ
11