Miele W 6073 (MC 23) Manuale di istruzioni per l'uso - Pagina 30
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Lavatrice Miele W 6073 (MC 23). Miele W 6073 (MC 23) 36.
Stampa la paginaNotes for the installer
The washer-extractor must be installed by
an approved service technician or an
authorised Service Dealer.
Installation
A concrete floor is the most suitable
installation surface.
Please note:
^ The machine must be level and securely
positioned.
^ Do not install the machine on a 'soft' base
such as floorboards as this could result in
more vibration during the spin cycles.
^ Do not install the machine on carpeted
flooring if the carpet pile blocks the
ventilation gap at the base of the machine.
^ If the machine is installed on a raised
plinth it should be secured using the butt
straps supplied with the machine.
If there is not already a concrete plinth
on-site, the Miele Spare Parts department
offer a steel plinth. Ensure the steel plinth is
secured to the floor, (see the enclosed
installation plan).
To avoid the possibility of frost damage on
no account install the machine in a room
which is exposed to frost.
The machine must not be moved without
the outer panels in place.
Transit fittings
Do not remove the red transit fittings marked
"A", "B". and "C" until when the machine has
been installed in its final position.
The machine must not be moved without
the transit fittings in place.
The transit fittings should be stored in a safe
place for future use. They must be re-fitted if
the machine is moved again.
30
Front transit fitting
The front panel must be taken off, (2 internal
torx T20 screws at the bottom) to remove the
front transit fitting (3 SW-13 screws) .
Rear transit fitting
"B" (1 piece)
The rear panel must be taken off, (just
loosen 15 internal torx T20 screws at the
bottom) to remove the rear transit fitting
(3 SW13 screws each).
"A" (1 piece)
"C" (1 piece)
M.-Nr. 06 006 842