Miele WS 5323 Manuale di istruzioni per l'uso - Pagina 26
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Lavatrice Miele WS 5323. Miele WS 5323 36.
Stampa la pagina
Problem solving guide
Fault messages
Repairs to machines operating with elec-
tricity or steam should only be undertaken
by a suitably qualified service engineer to
ensure safety. Unauthorised repairs could
be dangerous.
If a programme has been interrupted or if
there has been a fault during the disinfect-
ing phase (wash time 2) the whole pro-
gramme will have to be repeated to ensure
that disinfection has been achieved.
Faults that occur before or after the start of a
programme are displayed flashing in the dis-
play.
PROGRAMME 25
PROGRAMME STOP
THROUGH POWER CUT
Press the Start button.
When power is restored press the Start X
button. This fault message can also indicate
that the winding protection of the drive motor
has overheated. - Allow the motor to cool
down.
PROGRAMME 25
PROGRAMME STOP
WATER INLET FAULT
Open water stopcock and press "Start button".
Open water stopcock and press the Start X
button.
PROGRAMME 25
PROGRAMME STOP
DRAIN FAULT
Clean drain system and press Start button.
Check the drainage system on site and press
the Start X button. A defective drain valve
should only be repaired by the service depart-
ment or their authorised agent.
M.-Nr. 05730940
COTTONS
COTTONS
COTTONS
PROGRAMME 25
PROGRAMME STOP
HEATING SYSTEM FAULT
Short circuit on heater sensor 1.
Call the Service Department.
PROGRAMME 25
PROGRAMME STOP
HEATING SYSTEM FAULT
Cut-out of heating sensor 1.
Call the Service Department.
PROGRAMME 25
PROGRAMME STOP
HEATING SYSTEM FAULT
Call the Service Department.
PROGRAMME 25
PROGRAMME STOP
DRIVE SYSTEM FAULT
Multiplug drive variants lacking.
Call the Service Department.
PROGRAMME 25
95°C
Main wash
Rinses
1
DRIVE SYSTEM FAULT
Clean the ventilation slot on the side wall for
the cooling fan.
Call the Service Department, if there is still no
drum movement 30 minutes after this mess-
age appeared.
PROGRAMME 25
PROGRAMME STOP
PEAK LOAD CUT OUT ACTIVE
At the end of the peak load cut out function
the programme continues automatically.
26
COTTONS
COTTONS
COTTONS
COTTONS
COTTONS
20 °C
COTTONS