Allmatic AS24 Manuale per l'installazione - Pagina 5
Sfoglia online o scarica il pdf Manuale per l'installazione per Unità di controllo Allmatic AS24. Allmatic AS24 10. Control unit for 1-2 motors 24vdc
Stampa la pagina
8. Adjusting threshold of the ampere sensor in slowing down
This procedure must ONLY be carried out by the installer and ONLY during the put in function of the system. For a correct programming, before
carrying out any modification, bring always back the door to the totally closed position.
Repeat the measure
of the torque
With the door in phase of slowing down
check, through a dynamometer, the pushing
force at the edge of the wing.
Repeat the measure
of the torque
9. Adjusting of the motors running velocity
This procedure must ONLY be carried out by the installer and ONLY during the put in function of the system. For a correct programming, before
carrying out any modification, bring always back the door to the totally closed position.
Press BLUE key (P2) and keep
it pressed.
1
The flashing switch on.
With the gate in movement,
2
check the running velocity.
Release BLUE key (P2).
The flashing switch off.
3
The new velocity is set.
Set the velocity during the
slowing down mode. Follow
4
the
procedure
paragraph 10.
WARNING: it is indispensable to carry out, after adjusting the desired running velocity, a new programming
of the strokes (see paragraph 6). Check also that the adjusting thresholds of the ampere sensor are still
suitable (see paragraphs 7 and 8).
WARNING: in case of total deletion of the memory (see paragraph 17), the running velocity will be set at its
default value, equal to 60%.
6-1622372
rev.5 04/02/2016
It is possible to turn the SLOW.DOWN.SENS. in
clockwise sense to increase the ampere sense
threshold.
The edge of the ampere sense
is too low
The edge of the ampere sensor
is too high
It is possible to turn the SLOW.DOWN.SENS.
trimmer in anti – clockwise sense to lower the
threshold of the ampere sensor.
It is possible to turn the SLOW DOWN VE-
LOCITY trimmer in clockwise sense to in-
crease the velocity of the motors.
The velocity is too low
The velocity is too high
It is possible to turn the SLOW DOWN
VELOCITY trimmer in anti clockwise sense to
lower the velocity.
of
the
ITA
ENG
FRA
ESP
DEU
POR
SLOW.DOWN.
AMP.SENS
SLOW.DOWN.
AMP.SENS
SLOW.DOWN.
VELOCITY
Keep pressed
BLUE key (P2)
SLOW.DOWN.
VELOCITY
Keep pressed
BLUE key (P2)
Pag 5 di 10