Miele DAG 1000 Istruzioni per l'uso e l'installazione - Pagina 12
Sfoglia online o scarica il pdf Istruzioni per l'uso e l'installazione per Cappa di ventilazione Miele DAG 1000. Miele DAG 1000 16. External blower
Anche per Miele DAG 1000: Istruzioni per l'uso e l'installazione (40 pagine)
Electrical connection
,WARNING
TO REDUCE THE RISK OF
FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
All electrical work should be
performed by a qualified electrician
in strict accordance with national
regulations (for USA: ANSI-NFPA 70)
and local safety regulations.
Installation, repairs and other work
by unqualified persons could be
dangerous.
Ensure that power to the appliance
is off while installation or repair work
is performed.
This external blower may only be
operated with Miele DA 6480 or
DA 6490 ventilation systems.
^ Verify that the voltage, load and
circuit rating information found on the
data plate, match the household
electrical supply before installing the
blower.
If there is any question concerning the
electrical connection of this appliance
to your power supply, please consult a
licensed electrician or contact Miele's
Technical Service Department. See
back cover for contact information.
WARNING:
THIS APPLIANCE MUST BE
GROUNDED
12
Important : To increase security
before the machine is installed, it is
recommended to install a protective
switch (30 mA).
^ Remove the cover from the external
blower.
^ Remove the cover of the terminal
box.
^ Install a suitable UL listed cable
clamp or conduit fitting at the power
cord feed-through (strain relief).
^ Install a power cord to the ventilation
system.
Flexible armored or nonmetallic cable
must be used.
Wire sizes must conform to the
requirements of the National
Electrical Code ANSI/NFPA 70 —
latest edition or Canadian Electrical
Code, C22.1 and C22.2 No.
113-M1984 (or latest edition), and all
local codes and ordinances. 14
gauge wire (minimum) is
recommended.
A U.L./CSA-listed strain relief must be
provided at each end of the power
cord.
^ Pass the power cord through the
strain relief.