HP 234664-002 - ProLiant - ML330T02 Manuale di implementazione - Pagina 18

Sfoglia online o scarica il pdf Manuale di implementazione per Desktop HP 234664-002 - ProLiant - ML330T02. HP 234664-002 - ProLiant - ML330T02 26. Visualization and acceleration in hp proliant servers
Anche per HP 234664-002 - ProLiant - ML330T02: Domande frequenti (4 pagine), Manuale di implementazione (35 pagine), Libro bianco tecnico (12 pagine), Aggiornamento del firmware (9 pagine), Panoramica (20 pagine), Manuale introduttivo (22 pagine), Manuale di risoluzione dei problemi (18 pagine), Manuale di implementazione (11 pagine), Manuale di installazione (2 pagine), Manuale di configurazione (2 pagine), Manuale introduttivo (19 pagine), Manuale di aggiornamento (9 pagine), Manuale di aggiornamento (16 pagine), Manuale introduttivo (10 pagine), Manuale di istruzioni per l'installazione (15 pagine), Brief tecnologico (9 pagine)

Windows Server 2008 installation for 32-bit and 64-bit

editions on ProLiant servers

Server deployment of Windows Server 2008 is supported through manual and assisted path

installation options. Use the steps below to complete a manual install of Windows Server 2008.

To prepare for installation, ensure that the following conditions are met:

The server selected for installation is listed as a recommended system platform in Table 2.

Any additional storage options added to the server are listed as a supported ProLiant storage

options in Table 4.

Any additional NICs added to the server are listed as a supported ProLiant Gigabit Ethernet NIC

in Table

Go to

www.hp.com/go/bizsupport

installations for the server.

Use the ROM-Based Setup Utility (RBSU) to set date/time and configure the boot controller order

(if necessary).

Use the Array Configuration Utility to configure the RAID settings for the server.

Install the HP Insight Management Agents only after SNMP is loaded and started.

NOTE

After installing Windows Server 2008 and before installing

the PSP, if installing HP Systems Insight Manager and agents,

be sure that SNMP is loaded and the service is started.

Update iLO 2 firmware to Version 1.29 (or later).

To install the Windows Server 2008 installation (for 32-bit and 64-bit editions), complete the

following steps:

Make sure that the server has a DVD drive (either native to the system or attached).

NOTE

A license key may be required to use iLO virtual media with HP

ProLiant ML or HP ProLiant DL servers.

Place the Windows Server 2008 media into the DVD drive and boot the server to the DVD to

begin the installation.

to obtain the supported ROM for Windows Server 2008