HP 3000 Series Manuale di installazione - Pagina 17

Sfoglia online o scarica il pdf Manuale di installazione per Desktop HP 3000 Series. HP 3000 Series 42. 9x9 to k class conversion
Anche per HP 3000 Series: Manuale (25 pagine), Manuale di aggiornamento (19 pagine), Manuale (20 pagine)

HP 3000 Series Manuale di installazione
Series 39/40/42 to 52 Field Upgrade
NOTE
At this point, the nameplate is still held in place by double-sided tape installed at the factory. Perform Step 4 to pry the
nameplate from the front panel. Pressure can be applied to the back side of the nameplate at two places: the bolt and a
small slot just below the bolt.
4. Insert a flatblade screwdriver into the slot below the bolt and gently push the nameplate forward. Then push the
nameplate bolt until the top edge of the nameplate separates from the front panel. Be careful not to scratch the paint
on the front panel. Discard the old nameplate. Remove any remnants of old tape from the front panel before
installing the new nameplate.
5. Remove protective backing from tape on back side of new nameplate and install.
6. Reinstall spacer, flat washer, ground, wire, and two nuts.
7. Reinstalled LED PCA.
8. Reinstalled and secure the shroud to the computer cabinet.
1-7