Miele SO Series Manuale di istruzioni per l'uso - Pagina 21

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Aspirapolvere Miele SO Series. Miele SO Series 46. Cordless stick vacuum cleaner
Anche per Miele SO Series: Manuale di istruzioni per l'uso (48 pagine)

Miele SO Series Manuale di istruzioni per l'uso
You can read more about this in "Bat-
tery charging state indicator (while
charging)".
Charging the battery (with wall
mounting) (Fig. 12)
There are 2 ways to store and charge
the vacuum cleaner in the supplied wall
bracket.
Before charging the battery for the first
time, you must read the information in
"Installation and connection" – "Gen-
eral battery information".
You will need a suitable location near
a free power socket for mounting the
appliance on the wall.
Wall mounting (Figs. 13 + 14)
The supplied wall bracket has a mount-
ing plate with a bag of screws attached
to the back.
Attach the mounting plate to the point
on the wall where you want the wall
mounting to be.
 Remove the bag of screws.
 Press the release catch at the bottom
of the wall bracket (Fig. 13).
 Remove the mounting plate from the
wall bracket by sliding it downward
(Fig. 14).
Attaching the mounting plate
(Figs. 15 + 16)
2 plugs and 2 T20 TORX screws are
supplied for attaching the mounting
plate to the wall.
You will also need a battery-operated
screwdriver or a drill (with a drilling di-
ameter of 6 mm).
Depending on how you decide to con-
figure your vacuum cleaner, select a
distance of 17 11/16" or 38 9/16"
(45 cm or 98 cm) between the bottom
edge of the mounting plate and the
floor (Fig. 15).
Be careful not to damage any electri-
cal in the wall.
 Attach the mounting plate to the wall
(Fig. 16).
Attaching the charging cable to the
wall bracket (Figs. 17, 18, + 19)
A cable compartment is located on the
underside of the wall bracket.
 Press both release catches on the un-
derside of the wall bracket and re-
move the cable compartment cover
(Fig. 17).
 Plug the supplied charging cable into
the opening from above (Fig. 18).
 Lay the charging cable in its guide
(Fig. 18).
 Refit the cover and close the cable
compartment (Fig. 19).
Connecting the accessories holder
(if required) (Fig. 20)
An accessories holder is supplied for
storing the three-piece accessory set
on the wall bracket (see "Using the ac-
cessories supplied").
 Push the accessories holder on to the
wall bracket as far as it will go.
en-US
175