DIAKAT BF-410 Manuale dell'operatore - Pagina 9

Sfoglia online o scarica il pdf Manuale dell'operatore per Macchina da pavimento DIAKAT BF-410. DIAKAT BF-410 11.

BF-410

Floor grinder

BEFORE STARTING

Regularly (before commencing work) check:

•

all covers and safety features

•

all locking leavers

•

state of tool's wear

The pressure of the tool can be increased by adding up to three additional weights, weighting 5 kg each.

If you need more down force (deeper cut) place additional weights (1 -3) on the pins provided and secure

with 3 fly nuts.

! ATTENTION! Never load more then 3 additional weights provided by the manufacturer. Never use for

additional burdening anything else then the weights provided by the manufacturer.

! ATTENTION! Never start the motor if the tool is touching the floor.

1. Loosen the locking leaver and set the handlebars to comfortable height, retighten the locking leaver. The

height of the handlebars should be approximately the waist height of the operator.

2. Connect the machine to 220V / 50 Hz mains, secure the cable by the holder on the handlebars, this will

prevent accidental rip out from the pin socket of the safety switch.

3. Grip the handlebars and tilt the machine over its rear wheel towards you so that the tool is NOT touching

the floor and is a safe distance from the surface to be grinded.

4. Hold the handlebars with your left hand so, that you can reach with your fingers the leaver of the safety

switch. With your right hand pres the yellow safety button and consequently pull the leaver towards the

handlebars – the motor will start running.

5. Release the yellow button and grip the handlebars with both hands. Slowly and carefully lower the tool

in to cut.

! ATTENTION! It is necessary to follow the instruction for controlling the machine immediately after you

lover the machine to touch the floor. In the first moments of operation it is necessary to find the balance

point of the machine, when the machine is not moving to either side but remains in one place and acquire

the feeling for controlling the machine.

The movement of the machine is controlled by slight tilting of the machine over the tools rotating edges.

Strana 8