Dialogic IP Board IPT10000C Scheda di installazione rapida

Sfoglia online o scarica il pdf Scheda di installazione rapida per Scheda di rete Dialogic IP Board IPT10000C. Dialogic IP Board IPT10000C 2. Ip board

Stampa la pagina

Dialogic

IPT10000C IP Board

Quick Install Card

Part Number 64-0082-02

Dialogic Corporation.

Before You Begin

Protecting the Board from Damage

CAUTION:

All computer boards are sensitive to

electrostatic discharge ("ESD"). Handle all static-

sensitive boards and components at a static-safe work

area, and observe anti-static precautions at all times.

If you are not familiar with ESD safety precautions, visit

http://www.dialogic.com/support/hwinstall

Unpacking the Board

Unpack the Dialogic

IPT10000C IP Board ("board")

according to the following steps:

Prepare a static-safeguarded work area.

Carefully remove the board from the shipping

carton and anti-static packaging. Handle the

board by the edges and avoid touching the

board's components.

Lay the board on the static-dissipative work

surface.

Note: Place boards in static-shielding bags when

carrying boards from station to station.

CAUTION: Do not remove the board from the anti-static

packaging until you are ready to install it. Observe

proper anti-static precautions at all times.

Installing the Hardware

Note: The hardware must be installed before the system

software.

1. Turn the power to the chassis OFF if you do not have

a live insertion system. If you have live insertion

capability, the power to the chassis can remain ON.

to learn more.

1. Power LED

2. Green LED: Link Established indicator for 100BASE-TX port

3. Green LED: Link Established indicator for 1000BASE-T port

4. Out of Service LED: Indicates board is out of service or in reset from

the host.

5. Board Extractor (with red locking tab)

6. J1: Connector to Compact PCI backplane

7. J2: Connector to Compact PCI backplane

8. J3: Connector to Compact PCI backplane

9. J4: Connector to Compact PCI backplane

10. J5: Connector to Compact PCI backplane

11. Baseboard retaining screw

12. Yellow LED: Activity indicator for 100BASE-TX port

2. Remove the cover plate or open front chassis door.

3. Select an empty peripheral expansion bus slot.

4. Use the slot's board guides as you insert the board

into the chassis slot. Make sure that the tabs on the

board extractors engage the guide holes in the

chassis card cage, then lock down the board

extractors until the red locking tabs snap shut.

Physical Description

Main Board

Rear I/O Module

13. Yellow LED: Link Not Established indicator for

1000BASE-T port

14. 100BT 0: Port 0 connector to 100BASE-TX Ethernet

Network

15. 100BT 1: Port 1 connector to 100BASE-TX Ethernet

Network

16. 1000BT 0: Port 0 connector to 1000BASE-T

Ethernet Network

17. 1000BT 1: Port 1 connector to 1000BASE-T

Ethernet Network

18. J5: Rear I/O module connector to Compact PCI

backplane

19. J3: Rear I/O module connector to Compact PCI

backplane

20. Rear I/O module retaining screw

CAUTION: cPCI backplane pins are bent easily. Make

sure that the board is seated with hand pressure before

fully seating board. If the board extractors are used to

seat the board, make sure to seat evenly.

Note: If the power to the chassis is on, power is

automatically applied to the board, the Out of Service

LED lights briefly and then goes out, and the Power LED

goes on.