AllPondSolutions CUV-136 Manuale - Pagina 12
Sfoglia online o scarica il pdf Manuale per Sterilizzatore AllPondSolutions CUV-136. AllPondSolutions CUV-136 17. Pond & aquarium uv steriliser
TROUBLESHOOTING
The Light on My CUV Unit Isn't Working
If the UV indicator on the top of the filter casing is not lighting up follow these
troubleshooting steps:
1. Clean the UV indicator.
2. Please check for signs of damage or water
ingress to quartz sleeve and bulb area. You might
need to replace your quartz sleeve, ballast and/or
O-Rings if that's the case. Ensure that all O-rings
are in place and well lubricated.
3. If you find that the UV light is still not operational,
check that you have power from the mains supply.
4. If you do have power from the mains supply,
check if you can see the UV is operational through
the viewing hole. If you aren't able to see it, try
performing a safety override. Locate the safety
override switch on the ballast end next to the UV
bulb fitting (as shown in the image on the right).
IMPORTANT!
NEVER look directly at the UV light.
Press and hold the small thin silver switch when
the power is on and the bulb should ignite. Please
test in a dark/ shadowed place and do not look directly at the bulb – we
recommend covering the bulb with kitchen roll or similar. You should still be
able to see the glow of the bulb through this.
5. If the above does not solve the issue replace the UV bulb.
6. If you find that the UV light is still not operational after the bulb replacement,
the UV ballast may have developed a fault and you will need to contact the
supplier of your unit to obtain replacement parts.
Please remember that UV bulbs for use in ponds should be replaced every 12
months.
UVC Leaks
If your unit is leaking follow these troubleshooting steps:
1. Check that the UVC inlet/outlet caps and O-ring have been correctly
assembled and that they are hand tight. Ensure the O-rings are intact, well
lubricated and not twisted or damaged.
2. Always secure the UVC inlet hose and outlet hose with a jubilee clip.