Miller ArcReach SuitCase 12 CE Manuale d'uso - Pagina 36
Sfoglia online o scarica il pdf Manuale d'uso per Sistema di saldatura Miller ArcReach SuitCase 12 CE. Miller ArcReach SuitCase 12 CE 48.
Stampa la pagina
6-3.
Cable Length Compensation (CLC)
Ref. 278794-A
OM-278792 Page 30
�
Complete Parts List is available at www.MillerWelds.com
1
�
CLC will only work with a compatible
power source.
�
Having a good clean connection with
the v-sense clamp will ensure CLC
works properly.
1 Cable
Length
Compensation
Indicator
Cable Length Compensation (ON)
After the feeder associates (see Section5-4
to the power source, CLC will appear in the
voltage display on the feeder. This indicates
the feeder is calculating for CLC. Within 5-10
seconds, preset voltage will appear on the
voltage display along with the CLC indicator
turning on.
Only the desired weld voltage needs to be
preset at the feeder without any manual
compensation for voltage loss in the weld ca-
bles. While welding the power source will au-
tomatically adjust it's voltage to compensate
for any voltage drop in the weld cables.
�
If the feeder is unable to calculate CLC
the indicator will flash. If this happens a
weld can be made and the CLC will be
calculated in the first few seconds of
the weld. The first few seconds of weld-
ing may be erratic due to the feeder
calculating CLC.
Turning Cable Length Compensation ON/
OFF
� Press and hold the Voltage Adjust knob
and the Wire Feed Speed adjust knob
simultaneously.
� P01 (P01 = CLC) will appear on the volt-
age display with either On or Off being
displayed on the wire feed speed/amps
display.
� Within 3 seconds, turn the Wire Feed
Speed adjust knob to toggle between
On and Off.
� When turned to On, the CLC indicator
will turn on within 3-5 seconds.
� When turned to Off, the CLC indicator
will turn off.
(CLC)