ABB Dodge Torque-Arm II Manuale di installazione e istruzioni

Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per Apparecchiature industriali ABB Dodge Torque-Arm II. ABB Dodge Torque-Arm II 2. Speed reducer belt guard assemblies

Stampa la pagina

Installation and Instruction Manual for Dodge

These instructions must be read thoroughly before installation or operation. This instruction manual was accurate at the time of

printing. Please see baldor.com for updated instruction manuals.

Note! The manufacturer of these products, Baldor Electric Company, became ABB Motors and Mechanical Inc. on

March 1, 2018. Nameplates, Declaration of Conformity and other collateral material may contain the company name of

Baldor Electric Company and the brand names of Baldor-Dodge and Baldor-Reliance until such time as all materials have

been updated to reflect our new corporate identity.

WARNING: To ensure that drive is not unexpectedly

started, turn off and lock out or tag power source before

proceeding.

Remove all external loads from drive before removing or

servicing drive or accessories. Failure to observe these

precautions could result in bodily injury.

WARNING: Ensure that all guards are properly installed

before proceeding. Exercise extreme care to avoid

contacting rotating parts. Failure to observe these

precautions could result in bodily injury.

WARNING: All products over 25 kg (55 lbs) are noted on the

shipping package. Proper lifting practices are required for

these products.

WARNING: Because of the possible danger to person(s)

or property from accidents which may result from the

improper use of products, it is important that correct

procedures be followed. Products must be used in

accordance with the engineering information specified

in the catalog. Proper installation, maintenance and

operation procedures must be observed. The instructions

in the instruction manuals must be followed. Inspections

should be made as necessary to assure safe operation

under prevailing conditions. Proper guards and other

suitable safety devices or procedures as may be desirable

or as may be specified in safety codes should be provided,

and are neither provided by ABB nor are the responsibility

of ABB. This unit and its associated equipment must be

installed, adjusted and maintained by qualified personnel

who are familiar with the construction and operation of

all equipment in the system and the potential hazards

involved. When risk to persons or property may be

involved, a holding device must be an integral part of the

driven equipment beyond the speed reducer output shaft.

Speed Reducer Belt Guard Assemblies

TORQUE ARM II BELT GUARD INSTALLATION:

Two different belt guards are available for the Torque-Arm

II speed reducer. One belt guard assembly is designed for

mounting in position "B" and the other belt guard assembly is

designed for mounting in position "C" as shown in Figure 1. It is

important that the mounting position of the Torque-Arm II Motor

Mount be determined prior to purchase of the belt guard as

these two guards do not interchange and will be attached to the

motor mount uprights.

POSITION B

Figure 1 - Belt Guard Mounting Positions

Torque-Arm II

POSITION C