Miller XT30 Manuale d'uso - Pagina 20
Sfoglia online o scarica il pdf Manuale d'uso per Sistema di saldatura Miller XT30. Miller XT30 44. Air plasma cutting and gouging
Anche per Miller XT30: Manuale d'uso (40 pagine)
Stampa la pagina
5-1.
Selecting A Location
Movement
Location And Airflow
18 in.
(460 mm)
5-2.
Connecting Gas/Air Supply
Ref. 251808-A
9/16 in.
wrench
crescent wrench
OM-253555 Page 16
�
Complete Parts List is available at www.MillerWelds.com
SECTION 5 – INSTALLATION
1
2
(460 mm)
loc_small 2018-08
1
3
18 in.
2
Do not move or operate unit where
it could tip.
Special installation may be re-
quired where gasoline or volatile
liquids are present — see NEC Ar-
ticle 511 or CEC Section 20.
1 Shoulder Strap
Use strap to lift unit.
2 Line Disconnect Device
Locate unit near correct input power supply.
�
Use only clean, dry air with 90 to 120
psi (621 to 827 kPa) pressure.
1 Gas/Air Inlet Opening
2 Hose (From Gas/Air Supply)
3 Teflon Tape
Obtain hose with 1/4 NPT right-hand thread
fitting. Wrap threads with Teflon tape (option-
al) or apply pipe sealant, and install fitting in
opening. Route hose to gas/air supply.