Miller 1038 Manuale dell'operatore - Pagina 6

Sfoglia online o scarica il pdf Manuale dell'operatore per Camera Accessories Miller 1038. Miller 1038 12. Fluid head

Operating Instructions

The operating instructions are described in six steps. Please

read and understand these instructions before using this

equipment. Do not omit any steps.

F l u i d H e a d S e t - u p .

1.1

Loosen the PAN HANDLE CLAMP fully then rotate the

PAN HANDLE until it is approximately perpendicular to

the THREADED STUD (fig. 3) and tighten the PAN

HANDLE CLAMP - avoid contact wear between the

serrations on the Fluid Head and the PAN HANDLE

CLAMP, if this occurs then unwind the PAN HANDLE

CLAMP further.

1.2

Ensure that the TRIPOD BOWL is approximately

horizontal. Place the Fluid Head into the TRIPOD

BOWL, adjust the BUBBLE LEVEL (fig. 3) such that

the bubble is inside the black circle and tighten the

CLAMP NUT.

1.3

Set the initial control settings as follows – see Figure 1

& 2:

•

Select Counterbalance to position 4 (top setting).

•

Select Pan & Tilt Drag to position 0.

•

Tighten the PAN LOCK, TILT LOCK and the

SLIDING PLATFORM LOCK.

Pan Handle Clamp

Pan Handle

Illumination Button

Threaded Stud

Clamp Nut

Fig. 4