Miller 1050 Manuale dell'operatore - Pagina 7

Sfoglia online o scarica il pdf Manuale dell'operatore per Camera Accessories Miller 1050. Miller 1050 13. Fluid head
Anche per Miller 1050: Manuale dell'operatore (13 pagine)

Stampa la pagina

Operating Instructions

2 Camera Set-up

2.1 Remove the CAMERA PLATE by pulling down the SAFETY

TAB while rotating the QUICK RELEASE KNOB to the left.

The CAMERA PLATE should pop out.

2.2 Refer to the Camera's owners manual for correct method

of attachment to the CAMERA PLATE.

2.3 Attach camera accessories and the battery to the camera,

it is recommended to estimate the camera's Centre of

Gravity (C of G) for the purpose of correctly positioning the

camera on the CAMERA PLATE. The camera's C of G can

be estimated by placing the camera on to a round rod and

then shifting it backwards or forwards until a balance point

– C of G - is achieved. It is recommended to identify this

point on the camera as it will be useful in step 2.6.

2.4 Attach the CAMERA PLATE to the camera and securely

tighten the screws.

2.5 Align the CAMERA PLATE with the SLIDING PLATFORM

and slide it in until the safety mechanism is engaged.

2.6 Release the SLIDING PLATFORM LOCK and slide the

SLIDING PLATFORM such that the camera's C of G is

directly above the centre axis of the Fluid Head and tighten

the SLIDING PLATFORM LOCK (fig.5). If this can not be

achieved then reposition the CAMERA PLATE on the

Camera – step 2.4. This will ensure that the system has

maximum stability.

C of G

Sliding Plate

Sliding Plate Lock

Safety Lock Knob

Fig. 5