Aquaport AQP-10CS Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Distributore d'acqua Aquaport AQP-10CS. Aquaport AQP-10CS 13.
Stampa la pagina
User's Manual & Warranty
inStruCtionS for uSe to filter Water
iMportant: Ensure rubber plug is in place when using the system to filter water. See page 6
Warning: Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
Step 1:
Before plugging unit in, we recommend washing all filter bottle parts (except filter cartridge)
with warm water and detergent and rinsing thoroughly. In addition, flush clean water through
the unit and drain out via the taps and drain plug at the rear of the unit. Tilt the unit back and
forth to remove trapped water from unit. Continue this process until no more water runs out of
the drain.
Step 2:
Before use - soak filter cartridge for approx. 20 minutes in cold water.
Step :
Ensure drain plug is secure on the unit and tighten in place.
Step :
Make sure filter cartridge is pushed firmly in place.
Step :
Pour 34 - 52 oz. / 1 - 1.5L of water into the unpurified water tank, allow water to filter through
to the purified water tank and to chill reservoir tank within unit.
Step :
Please note: First filtration will take longer than subsequent.
Step :
Add a further 34 - 52 oz. / 1 - 1.5L of water to completely fill the filter bottle.
Step 8:
Discard water from first refill through drain plug at rear of unit. Tilt the unit back and forth
to remove trapped water from unit. Continue this process until no more water runs out of
the drain.
Step 9:
Repeat steps 5 & 7.
Step 10:
Place lid on top and set filter change dial to indicate the month of your installation. This device
will then indicate at 'Replace' mark the recommended month in which you should replace the
filter cartridge. We recommend a minimum change every 2 months or approx 40 Gallons /
150 Litres.
Step 11:
Plug in unit, turn on rear power switch allow the unit to cool water and use.