Burl Audio B2 Bomber DAC Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Convertitore multimediale Burl Audio B2 Bomber DAC. Burl Audio B2 Bomber DAC 17. With dante

There are 3 ways to clock the B2 Bomber ADC/DAC with Dante:

1. B2 ADC/DAC set to Internal. BKII card set to External (Recommended)

2. B2 ADC/DAC set to External Clock, BKII card set to External

3. B2 ADC/DAC set to Dante, BKII card set to Internal

SEE FIGURE 12 (NEXT PAGE) FOR B2 INTERNAL CLOCKING DIAGRAM:

CLOCKING B2 BOMBER ADC/DAC TO INTERNAL WORD CLOCK:

1. Set B2 front panel to INT

2. Open Dante Controller, select DEVICE INFO

3. Double Click on device "B2-xxxxxx"

4. Click on CLOCK STATUS. (Fig. 11, below)

5. Set B2 Bomber to "Preferred Master", and "Enable to sync to External

6. Make sure each device including host DAW is set to correct sample rate in

Fig. 11: shows B2 ADC on Internal clock. Dante card is synced to B2 clock. (Recommended)

NOTE: PREFERRED MASTER REFERS TO DANTE NETWORK, NOT B2 FRONT PANEL!

DANTE CLOCKING:

Device Config (as per step 8, page 9)