Aquarium Co-Op Air Pump Istruzioni

Sfoglia online o scarica il pdf Istruzioni per Acquari Aquarium Co-Op Air Pump. Aquarium Co-Op Air Pump 2.

Aquarium Co-Op Air Pump Instructions

Note:

•

Do not attempt to disassemble. Disassembling will void the 1-year warranty.

•

Do not submerge the air pump in water, and do not let the power plug and USB cable get wet.

•

If the air pump is placed below the rim of the aquarium, use a check valve to prevent water from flowing

out of the fish tank and onto the air pump whenever the power is off.

Installation Guide:

1. Open the rubber flap protecting the USB Type-C outlet and plug in the USB cable. The USB Type-C

connector plugs into the air pump, while the USB Type-A connector should already be plugged into the

USB power adapter.

2. On the other end of the air pump is one or two air pump outlets, depending on the model. Connect

airline tubing to each of the air pump outlets, and then connect the other end of the airline tubing to an

air stone, sponge filter, or other air-driven device. (Make sure to connect two air-driven devices when

using the dual outlet model.) If the air pump is located below the rim of the aquarium, cut the airline

tubing between the air-driven device and air pump, and connect a check valve in between. The end of

the check valve with the flapper (which looks like a colored or horizontal bar) should be facing the air

pump. If you install the check valve backwards, no air will flow when you turn on the air pump, so just

flip the check valve around.

3. Once the air-driven device is placed in the aquarium, plug the

USB power adapter into an electrical outlet. The battery

indicator light turns green to display the amount of

rechargeable battery life and slowly blinks while actively

charging. To prevent water from flowing down the USB cable

into the electrical outlet, create a "drip loop" with the USB

cable so that part of the cord dips down lower than the outlet.