Aquarium Co-Op Heater Istruzioni - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per Acquari Aquarium Co-Op Heater. Aquarium Co-Op Heater 2.

4. To adjust the heater to the desired temperature, press the SET button once on the temperature

controller. While the temperature display is still blinking, press the SET button again to change the

desired temperature by 1°F increments. (The desired temperature cycles from 64°F to 91°F, meaning

that you need to increase the heater up to the highest temperature setting of 91°F before it goes back

down to 64°F.) When the desired temperature is reached, do not touch the SET button for 3 seconds.

Once the blinking stops, the desired temperature has been saved.

5. To remove the heater from the water, unplug the heater and let it cool for 10 minutes before touching it.

To do a large water change that exposes the heater to air, unplug the heater, change the water, and

then plug in the heater after the tank is filled again.

Error Codes and Indicator Lights:

Code

Heater is out of water

Internal temperature probe is

damaged

Water temperature exceeds 97°F

Red

Heater is actively heating the water

Light

Yellow

Heater has reached 17,520 hours

Light

of service (2 years)

Cause

Recommended Action

Submerge the heater completely

underwater

Unplug the heater and contact

Aquarium Co-Op customer support

Operate the heater at a temperature

cooler than 97°F

No action needed

Consider replacing the heater for

optimal reliability