Burndy Continental Industries thermOweld CR-25 Istruzioni
Sfoglia online o scarica il pdf Istruzioni per Cavi e connettori Burndy Continental Industries thermOweld CR-25. Burndy Continental Industries thermOweld CR-25 2. Thermoweld grounding connections - cable to ground rod
Stampa la paginathermOweld
INSTRUCTIONS FOR THERMOWELD GROUNDING CONNECTIONS - CABLE TO GROUND ROD
CR-1
Place end of cable under
the center of the tap hole.
Cable must sit on top of
ground rod. Use locking
pliers or a clamp on the rod
below the mold to prevent
it from slipping when the
mold is fired.
CR-3
Place cable into mold and secure
mold to ground rod with backing plate
attachment. Support mold to keep
it from sliding down the ground rod
when welding with locking pliers or
clamp below mold.
CR-17
Place end of tap cable under center of
tap hole. Run cable must sit on top of
the ground rod. Use a pair of locking
pliers or a clamp below mold on ground
rod to support the mold and prevent
slipping.
+1 (918) 627-5210 • 1-800-558-1373 • WWW.THERMOWELD.COM
ELECTRICAL GROUNDING • CATHODIC PROTECTION • ELECTRIC UTILITY • RAIL
®
The Contractors Choice
CR-25
Place cables into mold and secure
mold to ground rod with backing plate
attachment. Support mold to keep
it from sliding down the ground rod
when welding with locking pliers or
clamp below mold.
Tel. +1.800.558.1373
Tel. +1.918.627.5210
www.thermoweld.com
CR-2
Place cable in the mold. Cable must
sit on top of ground rod. Use locking
pliers or a clamp on the rod below
the mold to prevent it from slipping
when the mold is fired.
CR-24
Place cables in mold. Bottom run cable
must sit on top of the ground rod. Use
a pair of locking pliers or a clamp below
mold on ground rod to support the mold
and prevent slipping.
ECN 2552 REV "F" 03/05/13
34-5381-04